Back to previous page

SB-1343 - Selecting the Correct Engine Mounting Bolts

Issued in May 1974, this Johnson Service Bulletin specifies the correct mounting bolt lengths for adjustable transom brackets and warns against inadequate thread engagement or bolts of unknown strength. A footnote also corrects SB-1342.

Johnson Outboards Service Bulletin factory letterhead
May, 1974
SUBJECT: Selecting the Correct Engine Mounting Bolts
MODELS: All with Adjustable Transom Brackets
Safety warning triangle
SAFETY WARNING
For proper engine mounting, the nuts used with the engine mounting bolts must have full thread engagement on the bolt.
The stainless steel bolts supplied with the engine are 3 1/2" except for those engines which are factory equipped with power trim in which case 4" bolts are supplied. In the majority of cases, the length of these bolts is more than adequate. However, for those installations where the transom is too thick and full nut engagement on the bolt threads cannot be obtained, 5 1/4" and 6" bolts are available.
The part numbers of our various engine mounting bolts are:
PART NO. LENGTH 318573 3 1/2" 313327 4" 318778 5 1/4" 313672 6"
These bolts are made with the material and strength required for this particular application; do not substitute bolts of unknown quality.
JOHNSON OUTBOARDS D. J. Leinonen Technical Data Coordinator
DJL/sn
NOTE: Post on your 55 thru 135 H.P. indexes under the heading "Lower Unit".
FOOTNOTE: "WE GOOFED", please correct service bulletin #1342 in paragraph numbered 1. The second 1973 in sentence starting 135 H.P. use P/N 317488 (72C) - should read 1974.