SB-1351 - Hard Starting

Issued August 1974, this Johnson Service Bulletin describes starting improvements for 1972 and 1973 50 H.P. rope-start outboards, including throttle cam changes, spark plugs, and a revised starter cover.

Johnson Service Bulletin letterhead
SB-#1351
August, 1974

SUBJECT:  HARD STARTING

ON MODELS:  1972 & 1973, 50 H.P. Rope Start
Our Service Department has received a few complaints of hard starting 1972
or 1973 outboards with rope start.  To overcome this condition, the following
changes are recommended:

  A.  Increase Neutral Speed Setting:

      1.  The preferred method is to replace the original 317597 cam with
          the 1974 P/N 319835 throttle cam marked "start". (Fig. 1)
          Grind follower cam interlock down to enable the center of the
          throttle cam roller to align with the "start" mark.

          Make sure pick-up timing is correct (3° ± 1°)

      2.  An alternate method is to remove follower cam interlock
          P/N 317347 and grind head down as illustrated so as to
          obtain a maximum neutral speed of 3500-4000 RPM (Fig. 2)

  B.  We also recommend installing hotter AC-M40FF plugs. These spark
      plugs have a lower voltage requirement and are more foul-resistant.

  C.  In addition to facilitate easier starting, we also suggest replacing
      the 387552 cover & eyelet assembly with the P/N 387075 which has a
      roller to reduce starting effort when pulling the rope upward, rather
      than straight out. (Fig. 3)
JOHNSON OUTBOARDS D. J. Leinonen Technical Data Coordinator
DJL/sn

NOTE:  Post on your 50 H.P. index under the heading "Miscellaneous".

NOTE:  FIGURE 1, 2 AND 3 ARE SHOWN ON THE REVERSE SIDE OF THIS BULLETIN.

                              (over)
Original factory Figures 1, 2 and 3: throttle cam comparison, grinding location, and cover and eyelet assembly

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Spark Plugs (Champion/NGK) & Spark Plug Gap Gauge

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 319835

Search for original or compatible replacement part 319835. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.