Johnson Service Bulletin SB-1352 - Water In Cylinders

Issued in September 1974, this bulletin identifies a potential exhaust manifold screw failure that could allow water into the cylinders of 1973 and 1974 Johnson 135 H.P. outboards.

Johnson Service Bulletin letterhead
SB-#1352
September, 1974
SUBJECT: Water In Cylinders
ON MODELS: 1973 or 1974, 135 H.P.
Johnson Outboards Service Department has received a number of complaints of water entering the cylinders from the exhaust manifold. When this problem occurs, make sure you check the long exhaust manifold screw, P/N 317972. If the head has broken off this screw or if it is not bottomed on the casting properly (resulting in low torque), water can enter the cylinders. Since this screw is located near the center of the exhaust manifold, you must remove the exhaust manifold cover to gain access to the screw.
Exploded exhaust manifold drawing identifying the cover, exhaust manifold and screw 317972
It is possible to remove the two screws at the bottom of the exhaust man- ifold cover by using a 1/4" drive 3/8" deep socket attached to a 1/4" drive speeder wrench. The exhaust manifold cover screws behind the ignition components can be reached by first removing the three screws holding the electrical component bracket to the powerhead and then lifting the bracket to expose the cover screws.
Normally, the exhaust manifold on the 135 H.P. will remain on the powerhead when the exhaust manifold cover is removed. If P/N 317972 screw is broken, both covers will come off together.
We recently changed the material in this screw to improve corrosion resistance and eliminate the problem of head breakage. These improved screws have heads stamped "B-8" and should be installed with a torque of 12-14 ft.lbs. (16-19 Nm). All 1975, 135 H.P. out- boards will have the improved screw installed.
JOHNSON OUTBOARDS D. J. Leinonen Technical Data Coordinator
NOTE: Post on your 135 H.P. index under heading "Powerhead".

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Cylinder Hone Tool, Piston Ring Compressor & Digital Bore Caliper

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 317972

Search for original or compatible replacement part 317972. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.