Johnson Service Bulletin SB-1354 (September 1974) - Fuel Pump Service Tip
Johnson's September 1974 service tip explains a fuel-pump test for 4 through 25 HP outboards that stall at approximately 1,500 RPM. The procedure uses clear fuel hose and connector P/N 376156 to distinguish a defective fuel pump from other fuel-delivery problems.

September, 1974
SUBJECT: Fuel Pump Service Tip
ON MODELS: 4 through 25 H.P.
As far as proper fuel pump operation is concerned, the most demanding engine speed is 1500 RPM, therefore, a fuel pump which operates well at idle or fast throttle positions may cause trouble if the engine is operated at approximately 1500 RPM. An engine experiencing fuel pump difficulties at this speed will tend to die but can be immediately restarted after priming with the primer bulb.
If you receive a customer complaint where the fuel pump is suspected, test the pump using the simplified procedure described below rather than the procedure described in your service manual. Equipment required for this test is a 3 to 4 foot length of fuel line hose (clear plastic 1/4" I.D. fuel hose is preferable so you can see the fuel rise from the tank) and a fuel line connector P/N 376156.
Assemble hose to connector and test as follows:
- With engine in test tank, place fuel tank so that fuel level in tank is 24" below the transom height.
- Start engine using regular hose and primer bulb assembly. Adjust speed to 1500 RPM.
- While engine is running, disconnect hose and primer bulb assembly at engine. Connect length of test hose to engine connector and place loose end of hose into tank through filler neck.
- If engine continues to run for 4 minutes at 1500 RPM, the fuel pump is good. If engine stops, replace pump and repeat test.
D. J. Leinonen
Technical Data Coordinator