Back to previous page

SB-1356 - Using Correct Propeller Thrust Bushing

Issued September 1974, this Johnson Service Bulletin distinguishes the propeller thrust bushings used on 1975 50 and 75 H.P. short-shaft engines from those used on 70, 75 long-shaft, and V4 outboards. The factory cautioned that installing the larger bushing on a short-shaft engine could damage the gearcase.

Johnson Service Bulletin original letterhead
SB-#1356
September, 1974
SUBJECT: Using Correct Propeller Thrust Bushing
ON MODELS: 1975, 50 thru 135 H.P.

The propeller attaching hardware supplied in the owners kit of 1975, 50 and 75 H.P. (short) engines is the same as that supplied with 1975, 70, 75 (long) and V4 engines except for the thrust bushing. The larger thrust bushing supplied with 70, 75 (long) and V4 engines will fit on the 50 and 75 H.P. (short) propeller shaft and it is possible to install the propeller. However, this must not be done since the larger thrust bushing would be jammed against the gearcase head and damage to the gearcase head will occur as soon as engine is run in gear.

The schematic below is included to aid you in identifying these thrust bushings.

Factory dimensional drawing, thrust bushing part 318841 for 70, 75 long-shaft and V4 engines Factory dimensional drawing, thrust bushing part 320305 for 50 and 75 horsepower short-shaft engines

JOHNSON OUTBOARDS

D. J. Leinonen

Technical Data Coordinator

DJL/sn
NOTE: Post on your 50 thru 135 H.P. indexes under the heading
"Lower Unit".

Thrust bushing identification

318841 - 70 H.P., 75 H.P. long-shaft and V4 models. 320305 - 50 H.P. and 75 H.P. short-shaft models. Compare the original factory dimensional drawings before installation.