SB-1361 - Electric Trolling Motor Service Tips
Issued in October 1974, this Johnson Service Bulletin covers transistor heat-sink compound, motor-adaptor waterproofing, and bow-mount latch release rope maintenance.

SB-#1361
October, 1974
SUBJECT: Service Tips
ON MODELS: Electric Trolling Motors
Recently we have received some reports of replacement transistors P/N #387034 on E2B-S models (12 volt bow mount) failing on first use after installation. In all cases the mechanics did not refill the cavity opening of the adaptor housing with Dow Corning #340 Silicone Heat Sink Compound or Wakefield Engineering Compound #122 as directed in the instruction sheet for the Transistor and O-ring package. This silicone compound is available at local electronics supply houses. If silicone compound is not available locally contact:
Newark Electronics
500 North Pulaski Road
Chicago, Illinois
60624 (312) 638-4411
500 North Pulaski Road
Chicago, Illinois
60624 (312) 638-4411
Dow Corning
4825 North Scott Street
Schiller Park, Illinois
60176 (312) 671-3100
4825 North Scott Street
Schiller Park, Illinois
60176 (312) 671-3100

When reassembling the motor to the adaptor be sure to apply OMC adhesive-M P/N #318535 to the surface marked (3) to assure a water tight fit. (Figure 1)
PAGE 2SERVICE BULLETIN #1361
JOHNSON OUTBOARDS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
A frayed latch release rope on the bow mount models may be caused by burrs in the eyelet in the bow arm. (Figure 2). The burrs can be removed by using emery or crocus cloth.

When replacing the latch release rope on the bow mount electric outboard tie a knot on the end of the rope where it is attached to the latch in the mounting bracket to keep it from slipping through the tie strap. (Figure 3)

JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
D. J. Leinonen
Technical Data Coordinator
NOTE: Post on your Electric Outboard index under heading "Motor and Electrical Group" and "Mounting Group".
DJL/kr