Issued in January 1975, this Johnson Service Bulletin describes the factory gear-shift linkage adjustment procedure for 1975 9.9 and 15 H.P. outboards, with four original illustrations.
SB-#1369
January, 1975
SUBJECT: Gear Shift Adjustment
ON MODELS: 1975 9.9 and 15 H.P. Models
The procedure listed below is the recommended method of adjusting
the gear shift linkage on 1975 9.9 and 15 H.P. motors.
1. Remove fuel hose on carburetor. Figure 1


Figure 1
Figure 2
2. Remove cotter pin and washer from shift lever to lock lever
link #319066. See Figure 2 & 3.
3. Place lever and hub assembly #386387 and shift lever #386114
in reverse position.
4. Adjust link and clevis to align with hole in shift lever to
shift lock link lever #319151. See Figure 4.
Do not exert any pressure on shift lever while making this
adjustment.
PAGE 2 SERVICE BULLETIN #1369
JOHNSON OUTBOARDS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085


Figure 3
Figure 4
5. Shorten link one turn more for installation. Slight pressure will
be necessary on shift lever when reinstalling link to shift lever
to shift lock link lever.
6. Install washer and cotter pin.
7. Connect fuel hose to carburetor using a new clamp strap #320107.
JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
NOTE: Post on your 9.9 and 15 H.P. index under heading "Lower Unit".
DJL/kr
This bulletin provides the 1975 9.9 and 15 H.P. gear-shift adjustment procedure and identifies shift linkage components #319066, #386387, #386114 and #319151.