Johnson Service Bulletin SB-1381 Rev. 1 (October 1975) - Battery Cable Extensions and Splicing Procedure

Factory guidance for extending battery cables on electric trolling outboards and 9.9 through 200 HP models, including recommended cable gauges and a soldered, heat-shrink-insulated splice.

Johnson Service Bulletin factory letterhead
SB-#1381 Rev. 1

October, 1975

SUBJECT:  Battery Cable Extensions and Splicing Procedure

ON MODELS:  Electric Trolling Outboard - 9.9 thru 200 H.P. Models

On installations that require longer battery cables, we recommend the following procedure:

Cut off approximately two feet of cable on each battery lead (two feet on red and two feet on black), then splice (see chart below) into each cable the desired length extension. Splices should be staggered (not side by side).

ENGINE4' EXTENSION10' EXTENSION18' EXTENSION
Electric Outboard6' of #10 GA12' of #8 GA20' of #6 GA
9.9 & 15 H.P.6' of #8 GA12' of #6 GA20' of #4 GA
25, 35 & 40 H.P.6' of #6 GA12' of #3 GA20' of #1 GA
50 & 55 H.P.6' of #4 GA12' of #2 GA20' of #1 GA
70 to 135 H.P.6' of #3 GA12' of #1 GA20' of #0 GA
200 H.P.6' of #2 GA12' of #0 GA20' of #00 GA

Cable splices should be kept up out of bilge to prevent laying in water.

Factory Figures A, B and C showing stranded cable insertion, wire wrapping and finished splice
PAGE 2SERVICE BULLETIN SB-#1381 Rev. 1
JOHNSON OUTBOARDS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

To splice cable, remove approximately one inch of insulation on each cable. Spread stranded cable (Figure A) open on each cable (Caution: wire is sharp - handle with care), then insert smaller cable into larger cable. Squeeze stranded wire with pliers.

Then wrap stranded wire with a small wire (Figure B) and twist with pliers to make compact splice. Apply liberal amount of solder flux (DO NOT USE ACID FLUX) and solder. Remove small wire wrapped around splice, slide heat shrink tube over splice and shrink with suitable heat source (Figure C).

JOHNSON OUTBOARDS

D. J. Leinonen
Technical Data Coordinator

DJL/kr

NOTE:  Post on your Electric outboard thru V-6 indexes under heading "Electrical."