Back to previous page

Johnson Service Bulletin SB-1387 (August 1975) - Oil Water Emulsion Draining From Gearcase

Factory troubleshooting instructions for oil-water emulsion draining from the gearcase on 1974 and 1975 Johnson 9.9 and 15 HP outboards. Covers exhaust housing water levels, seal inspection, and enlarging the impeller housing bleed hole from 1/16 inch to 11/64 inch.

Johnson Service Bulletin factory letterhead
SB-#1387
August, 1975 SUBJECT: Oil Water Emulsion Draining From Gearcase ON MODELS: 1974 and 1975 9.9 and 15 H.P. We have received several reports of customer complaints of an oil-water emulsion draining from the small drain hole in the forward part of the gearcase. Usually these reports indicate the engine is being used extensively at very low speeds. We have found that the condition is a result of a lower than normal water level in the wall-of-water within the exhaust housing and can be corrected as follows: Operate the engine in the test tank until completely warmed-up. Lower the water level in the test tank to underside of the cavitation plate. At idle speed, water should be coming out of the dump water holes. See figure 1. If no water is coming out of the holes: exhaust only indicates a low water level in the wall-of-water. This is most likely caused by a leaking seal at the bottom of the inner exhaust tube. Replace this seal if necessary. If a variable depth test tank is not available, mount the engine on a motor stand, remove one of the bottom screws from either upper mount. Using a small tube, fill the outer exhaust housing with water until water runs out of the dump water holes. Water will also come out of the drain hole in the front of the gearcase. If any water comes out of the propeller hub, the seal at the bottom of the inner exhaust tube is bad and should be replaced. If water comes out from the lower mount area the seal between the water pump and exhaust housing is bad and must be replaced. With gearcase removed, check the position of driveshaft in impeller housing seal. It should be centered. If it is not, leakage here could result in lower than normal water level in the wall-of-water.
PAGE 2SERVICE BULLETIN #1387
JOHNSON OUTBOARDS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
Remove the impeller housing and enlarge the bleed hole from 1/16" to 11/64". See figure 2. During reassembly, make sure driveshaft is centered in impeller housing seal.
JOHNSON OUTBOARDS D. J. Leinonen Technical Data Coordinator
DJL/kr NOTE: Post on your 9.9 and 15 h.p. index under heading "Lower Unit."
Figure 1: engine cross section showing exhaust relief hole, proper water level, inner exhaust housing, seal, impeller housing, and dump water holesFigure 2: enlarge impeller housing bleed hole
Figure 1
Figure 2

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

NMMA TC-W3 2-Stroke Marine Outboard Oil & Oil Mixing Ratio Bottle

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.