SB-1393 - Trim and Tilt Cylinder Assemblies
Issued in October 1975, this Johnson Service Bulletin introduces replacement trim and tilt cylinder assemblies for 1973-1976 50 through 135 H.P. outboards and explains compatibility with earlier hydraulic hoses.

SB-#1393
October, 1975
SUBJECT: P/N 172667, Trim Cylinder Assembly
P/N 172822, Tilt Cylinder Assembly
ON MODELS: 50 thru 135 H.P. - 1973 thru 1976
Trim and tilt cylinder assemblies are now available for all OMC
power trim and tilt units. P/N 172667 (suggested list price
$61.25) and 172822 (suggested list price $69.00) are complete
assemblies ready for installation.
The 1976 Accessories parts catalog and Master Parts Price List
will include these two assemblies.
Prior to the installation of a tilt cylinder, check the end fittings
on hydraulic hose running between pump and tilt cylinder. If
fittings are aluminum or stainless steel, tilt and trim is early
design. On these units, installation of the tilt cylinder will be
easier if you use P/N 172839 hose, elbow and O-ring kit. If an
early design hydraulic hose is used, the end cap of tilt cylinder
must be removed to assemble hose to cylinder. This operation is
not necessary if P/N 172839 kit is used.
Please refer to OMC Parts and Accessories service bulletin PA-1022
for service tips and troubleshooting procedures. Additional copies
can be obtained by contacting OMC Parts and Accessories Service
Department, Galesburg, Illinois 61401.
JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
DJL/kr
NOTE: Post on your 50 thru 135 H.P. indexes under heading "Mis-
cellaneous" and on your Miscellaneous index under heading
"Accessories."