SB-1398 - Proper Mounting of Engine

Issued in January 1976, this Johnson Outboards Service Bulletin warns dealers to use all supplied transom mounting hardware when installing 200 H.P. V-6 outboards. The reverse side illustrates the proper mounting plate and support plate arrangement.

Johnson Service Bulletin factory letterhead
SB-#1398
January, 1976
SUBJECT: Proper Mounting of Engine
ON MODELS: 1976 200 H.P. Outboards
Safety warning
Safety Warning
It has come to our attention that some dealers are installing 200 h.p. motors on boats without using all the mounting hardware supplied.
In addition to the hexbolts, washers, and nuts, it is essential that the transom mounting plates and support plates be installed in accordance with the installation instructions found in each 200 h.p. owner's manual (Pages 9 and 12). If these plates are not installed and the engine were to strike an underwater object, there is an increased chance of transom bracket breakage resulting in sudden operator loss of control.
Under the Federal Boat Safety Act of 1971, you, the dealer, are defined as a manufacturer when you install equipment and alter boats (as in rigging) and therefore are responsible for proper rigging.
To protect yourself and to assure your customers of the safest possible installation of their motor, install the motor according to the installation instructions, using all the hardware furnished with the motor.
NOTE: CORRECT INSTALLATION PROCEDURE ON BACK
JOHNSON OUTBOARDS
D. J. Leinonen Technical Data Coordinator
DJL/kr
NOTE: Post on your V-6 index under heading "Lower Unit".
Factory mounting illustration showing flat washers, hex nut, retainer, hex bolt, mounting plate and support plate

Related factory publications

See the factory 1976 200 H.P. owner's manual, pages 9 and 12, for the installation instructions cited by Johnson.

1970-1980 Johnson Service Bulletin Index

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

3/8" Drive Click Torque Wrench (Inch-Pounds) & Blue Threadlocker

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.