SB-1406 - Important Service Information
Issued in January 1976, this Johnson Service Bulletin increases the recommended cylinder-head bolt torque for 1976 55 H.P. outboards to 18-20 foot-pounds and emphasizes customer education about proper engine break-in.

SB-#1406
January, 1976
SUBJECT: Important Service Information
ON MODELS: 1976 55 H.P.
▣ NOTE
I.
We have had reports of water leakage into the powerhead and,
on occasion, cylinder head gasket blowout. Our testing has
shown that this problem can be corrected by increasing the
torque on the cylinder head bolts to 18-20 foot pounds from
the currently recommended 14-16 foot pounds. This higher
torque is being applied to all new 55 h.p. engines built.
As part of your pre-delivery inspection on new engines, you
should check the torque and increase it to 18-20 foot pounds
(follow the tightening sequence shown in Figure 5-43 in your
service manual) where necessary. Any 1976 55 h.p. engines
brought in for routine service should also have the higher
torque applied.
Please make a note of this torque change on page 2-3 of your
1976 55 h.p. service manual.
II.
We want to reemphasize to you the need of advising your customers
of the importance of faithfully following the break-in instructions
as explained in the owner's manual. This information should
be reviewed with the customer at the time of delivery of the
engine. It should be pointed out that proper break-in is the
best single insurance policy for a long trouble-free engine
life.
JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
DJL/kr
NOTE: Post on your 55 h.p. index under heading "Powerhead."
Related factory information
1976 Johnson 55 H.P. service manual, page 2-3 (cylinder-head bolt torque) and Figure 5-43 (tightening sequence).