Johnson Service Bulletin SB-1412 - Change in Choke Linkage

Issued April 1976, this bulletin documents revised choke linkage and solenoid adjustments for 1976 Johnson V-4 outboards, including production serial numbers and wiring orientation.

Johnson Service Bulletin letterhead
SB-#1412
April, 1976
SUBJECT: Change in Choke Linkage
ON MODELS: 1976 V-4's
We recently changed the choke linkage on our V-4 engines to
improve the choke function. A solid link similar to the type
used on the V-6 engines is now being used.
Choke solenoid adjustment is similar to the instructions given
on page 3-13 of the V-6 service manual. These instructions
with applicable V-4 changes are shown below.
CHOKE SOLENOID ADJUSTMENT
a. Loosen solenoid clamp screws.
b. Close choke valves by pushing solenoid plunger into
solenoid. If necessary, move solenoid so that choke
valves close completely.
c. With plunger held so that choke valves are still in
the closed position, move the solenoid so that plunger
is bottomed in solenoid.
d. While continuing to hold plunger, move solenoid away
from plunger (down 1/32") and tighten clamp screws.
e. Check to make sure that plunger slot does not bind
on key in solenoid.
The solid link choke system is used on V-4 engines starting
with the following model and serial numbers:
85EL76 4558668 115ETL76 4580320
85ETL76 4567388 135EL76 4583084
115EL76 4571715 135ETL76 4587179
PAGE 2 SERVICE BULLETIN SB-#1412
JOHNSON OUTBOARDS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
When the choke solenoid was modified recently, the ground and
positive leads changed position in relationship to the slot on
the solenoid plunger. Therefore, the ground wire should face
the front and the positive wire should face the rear so that
the wiring can be attached easily. Be sure that the linkage
does not bind.
JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
DJL/kr
Footnote: 1. New bushings, P/N 387618, which are designed to
eliminate play between the motor tube and mounting
tube on E4BS and E2BS electric outboards are
available from your OMC Parts Distributor.
NOTE: Post on your 85, 115, and 135 H.P. indexes under heading
"Carburetion".

Historical notes

The bulletin references the V-6 service manual, page 3-13, for the related choke solenoid adjustment procedure. It also notes replacement bushings P/N 387618 for E4BS and E2BS electric outboards.

1970-1980 Johnson Service Bulletin Index

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Digital Multimeter, Marine Heat-Shrink Butt Connectors & Wire Loom

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 387618

Search for original or compatible replacement part 387618. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.