Johnson Service Bulletin SB-1413 (April 1976) - New Cylinder Head Gasket Coating

Johnson introduced factory-coated cylinder head gaskets for 9.9 through 200 HP outboards. Gaskets marked “DO NOT USE SEALER” should be installed without additional gasket sealing compound.

Johnson Service Bulletin factory letterhead
SB-#1413

April, 1976

SUBJECT: New Cylinder Head Gasket Coating

ON MODELS: 9.9 through 200 H.P.

Until now, the outboard service manuals have recommended coating both sides of the head gasket with OMC Gasket Sealing Compound before installation. We recently added a coating to 9.9 through 200 h.p. gaskets which eliminates this requirement thus speeding the installation. Gaskets which have this coating will be stamped "DO NOT USE SEALER" as shown in the illustration. These new style gaskets are being phased into production and service. When you do start receiving them, it is important that you not use a gasket sealer since it may be incompatible with the factory applied coating.
Factory drawing of coated cylinder head gasket marked DO NOT USE SEALER
JOHNSON OUTBOARDS D. J. Leinonen Technical Data Coordinator
DJL/kr
NOTE: Post on your 9.9 thru 200 h.p. bulletins under heading "Powerhead".