SB-1415 - Throttle Cam Adjustment Tool

Issued in April 1976, this Johnson Service Bulletin explains how to make a simple throttle cam adjustment tool from an alligator clip and stiff wire, and demonstrates its use on 2 H.P. and 6 H.P. outboards.

Johnson Service Bulletin factory letterhead
SB-#1415
April, 1976
SUBJECT: Throttle Cam Adjustment Tool
ON MODELS: All Outboards
Proper setting of the throttle pickup on the throttle cam is important for obtaining good overall running qualities together with the best possible fuel economy. Sometimes though, it is difficult to tell when the carburetor's throttle shaft first begins to move. The tool described below exaggerates this movement making it easy to achieve proper adjustment.
As you can see, the tool is simply made from a common alligator clip and a piece of stiff wire; the only parts modification being grinding a large diameter on one side of the clip.
▣ NOTE
When using this tool, always attach it to the end of the throttle shaft opposite the cam follower. This will insure a more accurate reading of throttle cam movement. Figure 1 and 2 show typical usage.
Factory Figure 1: throttle cam adjustment toolFactory Figure 2: throttle cam adjustment toolFactory Figure 3: throttle cam adjustment tool
JOHNSON OUTBOARDS
D. J. Leinonen Technical Data Coordinator
DJL/kr
NOTE: Post on 2 through 200 H.P. indexes under heading "Carburetion."

Factory references

Factory illustrations show a 2 H.P. application with wire bent 90 degrees, a typical 6 H.P. application, and the modified alligator clip. File under Carburetion in the 2 through 200 H.P. service indexes.