Johnson Service Bulletin SB-1420 (June 1976) - Retorquing of the Cylinder Head Bolts

Johnson's June 1976 bulletin reiterates the need to retorque cylinder head bolts before delivery of new 2 through 200 HP outboards to prevent water entering the cylinders. It refers to the earlier Service Bulletin SB-1216 and the applicable service manual for torque values and sequence.

Johnson Motors Service Bulletin factory letterhead
SB-#1420

June, 1976

SUBJECT: Retorquing of the Cylinder Head Bolts

ON MODELS: All 2 H.P. through 200 H.P.

We continue to receive reports of new engine failure due to
water entering the cylinders. This condition is usually
caused by low cylinder head bolt torque.

On service bulletin #1216 we recommended retorquing the
cylinder head bolts before the outboard is delivered to the
customer. This procedure should still be followed on every
new engine since cylinder heads often loosen after
factory test and initial storage. Some gasket material may
also be more sensitive to high temperature.

When retorquing the cylinder head bolts, always follow the
recommended torque values and sequence of torquing illustrated
in your service manual.

JOHNSON OUTBOARDS D. J. Leinonen Technical Data Coordinator

DJL/kr

NOTE: Post on your 2 through 200 H.P. indexes under heading
"Powerhead".

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Universal Marine Control Cable Connectors & Marine Grease

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.