SB-1422 - Hard Starting in Cold Weather

Issued in June 1976, this Johnson Service Bulletin describes a twelve-step choke linkage and warm-up adjustment procedure for 1976 200 H.P. outboards to improve cold-weather starting.

Johnson Service Bulletin factory letterhead
SB-#1422
June, 1976
SUBJECT: Hard Starting in Cold Weather
ON MODELS: 1976 200 H.P.
We have received reports of 200 h.p. engines being difficult to start in cold weather. Our testing has shown that the problem can be corrected by making the following changes:
1. Remove the air silencer cover and base from engine.
2. Remove and discard the choke unloader link P/N 321172 and its nylon retainers from upper carburetor. See Figure 1. (Removing this link was a running change in production, so it may not be found on engine.)
3. Remove choke linkage from starboard side of carburetors.
4. Remove and discard the center link and loosely reassemble the upper link to lower link. See Figure 2.
5. Install linkage assembly into upper and middle carburetor's nylon retainers. See Figure 3.
6. With upper and middle carburetor choke plates fully closed, center the clamp on linkage rods so approximately 1/8" of each rod extends beyond the clamp. Tighten clamp screw.
Original factory Figure 1Original factory Figure 2Original factory Figure 3Original factory Figure 4
PAGE 2
SERVICE BULLETIN #1422
JOHNSON OUTBOARDS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
7. To insure that lower carburetor choke is completely inoperative, attach a P/N 378984 arm assembly to choke shaft. See Figure 4.
8. Reinstall air silencer base making sure arm assembly is against the base and choke valve is in the "open" position.
9. With the manual choke override switch (on the control box) in the "on" position, choke valves will look as shown if modification has been done correctly. See Figure 5.
10. Reinstall air silencer cover.
11. With engine running (in lake or test tank), control box shift lever in neutral and the warm-up lever in the "start" position, readjust the warm-up adjusting screw in control box until tachometer reads between 4500 and 5000 R.P.M. See Figure 6.
12. A check of the throttle cam will show that the pick-up point has been advanced approximately 1/8". Make a new mark on the throttle cam at this point. See Figure 7.
NOTE
By advancing the spark, the engine speed after starting is also increased. This may be in excess of 5500 R.P.M. on a hot engine. If this does occur, advise the customer that he should not fully engage the warm-up lever when engine is hot. (Air temperature 50 F or higher or when engine has been run within 3 hours.)
Original factory Figure 5Original factory Figure 6Original factory Figure 7
JOHNSON OUTBOARDS D. J. Leinonen Technical Data Coordinator
DJL/kr
NOTE: Post on your V-6 index under heading "Carburetion".

Related factory publications

See the 1970-1980 Johnson Service Bulletin Index for other factory service information.