Back to previous page

SB-1425 - Armature Plate Bearing Assembly and Lubrication

Issued June 1976, this Johnson Service Bulletin explains correct lubrication and updated armature plate bearing replacement for 1974-1976 Johnson 9.9, 15 and 40 H.P. engines and 1976 35 H.P. engines. Both original factory pages are reproduced below, with searchable instructions and the original exploded technical illustration.

Johnson Outboards Service Bulletin factory letterhead
SB-#1425

June, 1976

SUBJECT: Armature Plate Bearing Assembly and Lubrication

ON MODELS: 9.9/15 H.P. 1974 - 1976; 35 H.P. 1976
40 H.P. 1974 - 1976

Improper lubrication of the armature plate bearing (delrin ring)
and the armature plate pilot can lead to armature plate wobble,
unstable timing, and damage to both the armature plate and the
cylinder and crankcase assembly.

The proper lubricant for the armature plate bearing is Johnson
outboard motor lubricant (50:1 oil) applied to the bearing groove
(inside diameter) only. See figure on back of bulletin. The
bearing top, bottom and outside is not lubricated. The armature
plate bearing is clamped between the armature plate and the
retainer and link assembly and should turn with them.

The armature plate bearing has been improved and it is recommended
that the earlier white or black parts be replaced with the later
dark brown #322435 part if any of the above motors are in for
ignition service.

The proper lubricant for the armature plate pilot bearing
(cast-in brass bearing) is OMC Moly Lube #173250, spread lightly on
the mating crankcase boss.

JOHNSON OUTBOARDS

D. J. Leinonen
Technical Data Coordinator
DJL/kr
NOTE: Post on your 9.9, 15, 35 and 40 H.P. indexes under heading
"Ignition".
(over)
Exploded Johnson armature plate assembly showing armature plate pilot bearing, Delrin ring, 50:1 oil lubrication point, crankcase boss and OMC Sea-Lube Moly Lube 173250 application point
SB-1425 - Factory armature plate bearing and lubrication diagram

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Inductive Ignition Timing Light & Feeler Gauge Set

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 322435

Search for original or compatible replacement part 322435. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.