SB-#1432
September, 1976
SUBJECT: Lower Mounts
ON MODELS: 175 and 200 H.P. - All, 140 H.P. - All,
85 and 115 H.P. - 25 Inch Transoms
SAFETY WARNING
The above listed Johnson models are high powered motors designed
to give stable boat performance on most boats with appropriate
horsepower ratings. The degree of stability will vary with
different boat-propeller-motor combinations. If a boat has a
tendency to be unstable ("fishtail") at high speed or in turns,
it may require optional motor mountings and/or twin cable steering.
The necessary mounts and/or steering kits to correct this
condition, if it exists for a particular combination of boat-
propeller-motor, are available through your OMC Parts and
Accessories distributor.
Twin cable steering must be used for the above listed motors in
dual installations.
There are three lower mounts used in the above listed model
motors which are alike in appearance and are installed in the
same manner.
Improper application of these mounts could seriously affect the
performance of the motor and possibly cause instability of the
boat.
Mount #387783 is designed for normal applications of the 85 and
115 h.p. 25 inch transom models, and the 140 h.p. in both the
20 and 25" transom models. This mount can be identified by its
red color and the part number appears in raised numbers.
Mount #387243 is designed for use with both the 175 and 200 h.p.
V-6 models in normal applications. This mount can be identified
by its blue rubber color and has the part number in raised
numbers on it also.
Mount #387998 is the high performance mount and should be used on
any of the above motors if the boat has a tendency to be unstable
("fishtail") at high speed or in turns and the installation of
twin cable steering has not eliminated the unstable tendency. This
mount can be identified by its green color and the part number in
raised numbers.
(over)
PAGE 2 SERVICE BULLETIN #1432
JOHNSON OUTBOARDS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
Under no circumstances are lower mounts to be installed other
than in matched pairs.
No substitution of mounts should be made from those called for
in the parts catalog, except as described above.
JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
DJL/kr
NOTE: Post on your 85 thru V-6 indexes under heading "Lower
Unit".
D. J. Leinonen