SB-1435 - Remote Control Assembly P/N 388182

Issued in May 1977, this Johnson Service Bulletin alerts dealers to incorrectly packed V-4 battery cables in certain 1977 V-6 remote control assemblies, which may cause hard starting.

Johnson Outboards Service Bulletin
SB-#1435
May, 1977
SUBJECT: Remote Control Assembly P/N 388182
ON MODELS: 1977 V-6
It has been reported that a few 1977 175 and 200 h.p. V-6 motors were shipped with the P/N 388181 V-4 instrument cable assembly instead of the P/N 388181 V-6 cable. The cartons are stamped correctly P/N 388182 however, they have the 388181 V-4 cable packed inside. Open the carton and measure the battery cables as shown in Figure 1.
If a 1977 V-6 hard starting problem is reported, inspect the battery cables first. The V-4 instrument cable assembly attached to the remote control unit, has lighter gauge battery cables and could cause slower cranking speeds and possible hard starting under some conditions.
The V-6 battery cables are approximately 3/8" O.D. #4 GA. vs 5/16" #6 GA. for the V-4 cables. See Figure 1.
Figure 1: remote control battery cables, V-6 3/8 inch and V-4 5/16 inch outside diameter
NOTE
Prolonged and excessive cranking, due to small battery cables or other problems, can cause premature wear and damage to starter motor.
If any V-4 cables are found in V-6 cartons, return the complete remote control assembly with all hardware to: Johnson Outboards Service Department, 701 Pershing Road, Waukegan, Illinois 60085, Attention: Harold Dunning. We will return a complete P/N 388182 V-6 remote control assembly on receipt of the incorrect assembly.
JOHNSON OUTBOARDS D. J. Leinonen Technical Data Coordinator
NOTE: Post on your V-6 index under heading "Electrical".

Factory reference

File under the V-6 index heading "Electrical".