Johnson Service Bulletin SB-1436 - 35 H.P. Motor Overheating

May 1977 Johnson factory service guidance for diagnosing overheating and inspecting cooling-system components on 35 H.P. outboards.

Johnson Service Bulletin letterhead
SB-#1436

MAY, 1977

SUBJECT: 35 H.P. MOTOR OVERHEATING

When a 35 H.P. engine has overheated due to insufficient cooling water reaching the powerhead it is a good idea to remove and inspect the #319577 inner exhaust cover for being warped.

A warped exhaust cover plate can cause exhaust gases to enter the cooling system creating enough pressure to keep cooling water from reaching the powerhead. This results in intermittent or consistent overheating whenever the engine is run.

Inspect the #321513 water tube guide and the #302497 grommet which are located at the front of the inner exhaust tube. Be sure to inspect the plastic spacer #322408 (short) or #322409 (long) above the water pump. Also check the cylinder head for flatness. These parts are subject to distortion when there is a lack of cooling water.

Check the thermostat and replace the cylinder head gasket. Then retorque the cylinder head and cover to specifications in the service manual.

Never run the motor out of water without cooling water from a fresh water flushing kit.

JOHNSON OUTBOARDS

D. J. Leinonen
Technical Data Coordinator

DJL/kr

NOTE: Post on your 35 H.P. index under heading "Powerhead".

Historical service reference

Johnson identified distortion of the inner exhaust cover and other cooling-system components as potential causes of recurring overheating after insufficient cooling-water flow. This reproduction preserves the factory part numbers and inspection instructions.