SB-1439 - Accessory Ignition Shut Off Device
This Johnson Service Bulletin describes inspection and replacement of the ignition shutoff face plate on applicable outboards and stern drives. It includes a safety warning and factory warranty reimbursement instructions.

SB-#1439
SUBJECT: PART NUMBER 172866 ACCESSORY IGNITION SHUT OFF DEVICE
△ SAFETY WARNING
CAN BE FOUND ON MODELS:
1. 1973-76 Johnson or Evinrude Outboards equipped
with Command Center or Power Pilot Single Lever
Remote Controls.
2. Outboards equipped with Remote Electric Starting
Kits.
3. OMC Stern Drives which have Plastic Threaded
Ignition Switches.
The tang (flange) on the face plate part number 122800 (see figure 1) provides greater assurance that the ignition key will be turned to the “OFF” position in an emergency, particularly should the key be loose in the lock due to corrosion, over or under lubrication, or any other cause.

Because this part is designed to assist in shutting the engine off in certain emergency situations, it is extremely important that the boat owner be certain that this part is properly maintained and that the part is in good operating condition.
As an aid to the boat owner in his responsibility in this regard, any personnel of yours performing service of any kind on any boats carrying this part, should inspect this part to check that it is in good operating order. Further, any new employee which you hire should be instructed in this procedure.
To be certain that there has been no damage to the unit from any cause (i.e., from the tang (flange) being bent or missing due to any outside force or any other cause) when you make your inspection, remove the present face plate and insert a new face plate Part No. 123435 (even if there is no damage to the part that is apparent to the eye).

Part No. 123435 can be identified by a square hole in the face plate.
Further, if you know personally of any owners of these devices you should contact them to arrange for this inspection. This should be done in addition to the inspection of any units which come into your shop for service.
As an aid to you in fulfilling your responsibility to your customers and as an incentive to inspect all units that come into your dealership, OMC will issue a credit voucher for a new Face Plate Part 123435 plus allow $7.50 for labor and handling.
Please fill out an Evinrude, Johnson, OMC Stern Drive or OMC Parts & Accessories warranty claim form for each unit reworked and submit to:
OMC Parts & Accessories
ATTENTION: SERVICE DEPARTMENT
3225 Prairie Drive - R.R. #5
Beloit, Wisconsin 53511
All claims must include model and serial number of the engine, and the owner’s name, address and signature. All removed Face Plates No. 122800 must accompany warranty claims.
JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
NOTE: Post on the 50 thru 200 H.P. indexes under heading “Ignition” and on the miscellaneous index under heading “Accessories”.
Factory publication notes
Original two-page Johnson Service Bulletin. Replacement face plate P/N 123435 supersedes the original face plate P/N 122800 for the inspection described above.