Johnson Service Bulletin SB-1441 (July 1977) - V-6 Lower-to-Upper Fuel Pump Hose

Factory guidance for 1977 Johnson 175 and 200 HP V6 outboards concerning a kinked fuel pump hose, lean running at high throttle, and replacement with molded hose P/N 323401.

Johnson Motors Service Bulletin letterhead
SB-#1441
July, 1977
SUBJECT: V-6 LOWER-TO-UPPER FUEL PUMP HOSE
ON MODELS: 1977 175 & 200 H.P.
There have been a few reports from the field that some 1977 175 and 200 H.P. motors are experiencing
a lean condition at high throttle settings.
The probable cause has been the kinking of the upper-to-lower fuel pump hose, #320572, see figure.
A new molded hose, #323401, is currently used in production and is available for service.
We recommend you check all V-6's brought in for service and in stock. If the hose is kinked, the
new molded hose, #323401 should be installed at once.
Failure to replace a kinked hose could result in a burned piston and other powerhead damage.
JOHNSON OUTBOARDS

D.J. Leinonen
Technical Data Coordinator
NOTE: Post on V6 index under heading "CARBURETION".
Factory exploded view of V6 fuel pump hose routing, replacement molded hose 323401, previously 320572

Technical reference

The factory illustration identifies the molded replacement hose 323401 (previously 320572). Inspect for kinking during service to prevent lean running and potential powerhead damage.