Johnson Service Bulletin SB-1451 (January 1978) - 9.9 and 15 HP Piston Rings

Johnson's inspection instructions for replacement piston rings 386279 and 386280, identifying incorrectly machined rings that could damage pistons and cylinders.

Johnson Service Bulletin letterhead
SB-#1451
January, 1978
SUBJECT: 9.9 AND 15 H.P. PISTON RINGS, P/N 386279 AND 386280
When installing new piston rings in a 9.9 or 15 H.P. motor, be sure that the piston rings are capable of fitting into the ring groove so that the piston ring is flush to or below the surface of the piston. It has been reported that some piston rings were incorrectly machined so that they could not properly fit into the ring grooves. When installed, these piston rings can protrude above the surface of the piston. While the piston can be installed in the cylinder with the incorrectly machined piston rings, the pistons and cylinders could be damaged within a short period of operation.
To check the piston rings for correct machining, insert the piston ring into the ring groove. Lay a straight edge along the side of the piston, as shown in Figure 1 and 2. Check several places around the circumference of the piston. A correctly machined piston ring will fit as shown in Figure 1. An incorrect ring will fit as shown in Figure 2.
If you find piston rings that are machined incorrectly, return them to your Parts Distributor for replacement.
Factory Figures 1 and 2: correct piston ring flush with piston surface and incorrect ring protruding above surface
JOHNSON OUTBOARDS
D. J. Leinonen
Technical, Data Coordinator
NOTE: POST ON 9.9-15 HP INDEX UNDER HEADING “POWERHEAD”