Back to previous page

SB-1456 - Good Electrical Connections

Issued March 1978, this Johnson Service Bulletin explains how to identify and correct improperly seated waterproof electrical connector pins and sockets. The factory dimensions, diagram, and installation procedure are reproduced below.

Johnson factory Service Bulletin header
SB-1456

March 1978

SUBJECT: GOOD ELECTRICAL CONNECTIONS

If you encounter electrical problems on outboard motors and OMC Stern Drives and Sail Drive units, they may be due to poor connections in the water proof connectors. The pins and sockets may be improperly seated in their connector halves resulting in poor or no connections.

Figure 2 shows the proper dimensions of the pins and sockets seated in their connectors.

Factory Figure 1: socket seating dimension 1/2 inch or 0.515 plus or minus 0.025; pin seating dimension 1/8 inch or 0.125 plus or minus 0.025.

To correct, use insert tool (OMC P/N 322697) to insert pins and socket to their proper depth. Use alcohol to lubricate the connector before installing pins or sockets. The alcohol does not leave a residue which could contaminate any part of the connector.

JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator

NOTE: Post on 4 thru V-6 index under heading “ELECTRICAL”.

CR-78-8

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Digital Multimeter, Marine Heat-Shrink Butt Connectors & Wire Loom

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 322697

Search for original or compatible replacement part 322697. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.