Johnson Service Bulletin SB-1463 Rev. 1 (August 1978)

1978 Johnson 35 HP water pump overheating at idle: affected models and serial numbers, impeller blade-height specifications, and corrective service procedures.

Johnson Motors Service Bulletin letterhead
SB-1463 Rev. 1
August, 1978
SUBJECT: 1978 - 35 H.P. WATER PUMPS

We have had some reports of 1978 35 H.P. motors overheating after a period of idling. This can be caused by insufficient output pressure at idle speeds. The models affected are those built before the serial numbers listed below:

MODELSERIAL NUMBER
358022463
358031926
358522453
358533501
 
35R784881847
35RL784886832
35E784890087
35EL784895278

The cause of the low output pressure has been attributed to the following:

1.Impeller P/N 388702 undersize on blade height.
2.Impeller housing out of flat (warped).
3.Gasket P/N 323311 (impeller housing to plate) assembled off center with respect to the impeller cup P/N 323008, hence causing the gasket to be trapped between the cup and plate P/N 323251 causing leakage. The gasket should only be trapped between impeller housing and plate.

This condition can be corrected by taking the following steps:

1.Replace plastic impeller housing with new housing P/N 390159 as available. Until new housing is available, use P/N 388890.
2.Measure the impeller blade heights at the tip where there is a flat surface, midway down the blade and also at the hub. Replace the impeller if the blade height is less than .746 inches or more than .754 inches.
3.Replace the gaskets, one on each side of impeller plate. Insure that upper gasket P/N 323311 is not off center and trapped between cup P/N 323008 and plate P/N 323251.
4.Install P/N 318452 washer under heads of water pump hold down screws.
CR 78-29
Johnson Outboards

D.J. Leinonen
Technical Data Coordinator