Johnson Service Bulletin SB-1466 - Integral Power Trim and Tilt Servicing

Issued July 1978, this bulletin describes revised hydraulic manifold components and the tools recommended for servicing integral power trim and tilt units.

SB-1466

July, 1978

SUBJECT: INTEGRAL POWER TRIM AND TILT SERVICING

The later 1978 production Integral Trim & Tilt Manifold includes a new pump control piston and spring system designed to prevent hydraulic lock-up and lost reverse lock position when trailing motor in tilted position. Manifolds designed to use this new piston can be identified by a “+” symbol on manifold castings under left trim cylinder cavity. The new type piston and springs must be used with this new manifold and cannot be used on manifolds without “+” stamp. To simplify the removal and installation of the Power Trim and Tilt units, we suggest that you use a Drag Link Socket which is available from your Snap-On-Tools Distributor.

Exploded factory manifold diagram showing eight numbered hydraulic components

The Drag Line Socket (shown above) is P/N A-26 with 1/2” drive. If necessary a Handle Adapter A-2 1/2” to 3/8” can also be purchased from your Snap-On-Tools Distributor.

NOTE: Post on 85 thru V-6 index under heading “Lower Unit.”

CR78-32

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Power Trim & Tilt Hydraulic Fluid & Spanner Wrench

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.