Back to previous page

SB-1470 - 25 & 35 H.P. Lower Mount System

Issued July 1978, this Johnson Service Bulletin explains changes to the lower motor mounts of 25 and 35 H.P. outboards, including the replacement bumper and port and starboard mount housings.

Johnson Service Bulletin factory letterhead
SB-1470

July, 1978

SUBJECT: 25 & 35 H.P. LOWER MOUNT SYSTEM

MODELS: 1977 & LATER 25 H.P.
    1976 & LATER 35 H.P.

The lower mount assembly on 25 & 35 H.P. motors was changed in mid 1977 to limit the vertical travel of the rubber mounts. Some field reports of mount failures were found to be caused by the motor striking an underwater object or hitting a sandbar. This would generate an upward force deflecting the motor mounts enough to allow the limit stops on the exhaust tube to pass over the limit stops on the steering bracket. In some cases the user noticed excessive motor movement under acceleration before any type of mount failure developed.

The change made in mid 1977 model 25 & 35 H.P. motors incorporates modifications to the lower mount housings, port and starboard, to accept a rubber bumper that acts to limit the vertical movement without affecting isolation.

If you have experienced this type of failure with the earlier model 25 or 35 H.P. motors, you can reduce the risk of such an occurrence by installing the improved parts as follows:

323107Bumper
323108Port Side Lower Mount Housing
323109Starboard Side Lower Mount Housing

For service on modified motors refer to 1977 or later parts catalogue.

Johnson Outboards

D. J. Leinonen
Technical Data Coordinator

NOTE: Post on 25 and 35 h.p. indexes under heading “Lower Unit.”

CR78-28