Back to previous page

SB-1474 - Application of Motor Decals

Issued July 1978, this Johnson Service Bulletin provides factory application procedures for RM type decals and pressure-sensitive decals used on all outboard models.

Johnson Service Bulletin factory letterhead
SB-1474

July, 1978

SUBJECT: APPLICATION OF MOTOR DECALS

MODELS: ALL MODELS

There are two types of decals currently used on all outboard motors - the RM Type and the Pressure Sensitive Decal. Application instructions which may help you in their use are as follows:

DECAL APPLICATION INSTRUCTIONS

RM TYPE DECAL

This type of decal can be identified by an “RM” printed on the back side of the decal or by the backwards printing on the decal.

1.

Immerse entire decal into solution P/N 277409 (mix according to instructions on jar) until entire paper backing is saturated. This usually takes less than 30 seconds but can vary.

2.

Apply decal, face down, on designated surface.

3.

Starting at the center, squeegee the decal towards the outside edge.

4.

Peel off paper backing, slowly, after about a minute. If paper tends to stick to the decal, apply more solution directly to the area.

5.

Wash face of decal thoroughly with a wet sponge.

PRESSURE SENSITIVE DECAL

This type of decal has a paper backing which is easily peeled off to expose an adhesive surface.

Small Decals

1.

Apply light film of diluted liquid dish washing soap to surface of motor to allow decal to be positioned without sticking to the motor surface.

2.

Remove 1/2 of paper backing.

3.

Place decal on surface, working from outside edge to center.

4.

Remove remaining paper backing and squeegee from center to outer edge.

Large Decals

1.

Apply light film of diluted liquid dish washing soap to surface of motor to allow decal to be positioned without sticking to the motor surface.

2.

Remove the “quick-strip” (a one to two inch strip) near the middle of the decal.

3.

Place decal in position and squeegee the center strip firmly.

4.

Remove the remaining paper backing, one section at a time, and squeegee in place by working from the center to outside edges.

Johnson Outboards

D. J. Leinonen
Technical Data Coordinator

NOTE: Post on miscellaneous index under heading “Engine Miscellaneous.”

CR78-45