Johnson Service Bulletin SB-1476 - Dual Remote Control Tilt & Trim Conversion

This 1978 Johnson bulletin explains conversion kits for dual V-4 or V-6 outboard installations and cautions against transferring incompatible remote controls between engines.

Johnson Service Bulletin factory letterhead
SB-1476

SUBJECT: 1978 V-4 OR V-6 REMOTE CONTROLS WITH TILT & TRIM SWITCH
DUAL INSTALLATION

When using the subject remote controls for dual motor installations, engineering recommends using the following kits:

Tilt & Trim Conversion Kit P/N 389728

This kit will permit altering one remote control by eliminating the tilt and trim switch on the control lever and providing tilt and trim switch for dashboard installation. In addition to the above, please note that adaptor kit P/N 385827 and spacer P/N 318463 are still required, as recommended in the parts catalog.

Tilt & Trim Cable Conversion Kit P/N 389726

This kit will permit customer to use an older remote control assembly (1973-1977) if customer is purchasing a 1978 motor equipped with tilt and trim and he previously had a tilt and trim motor on his boat.

The jumper wire provided in this kit will permit connecting the tilt and trim cable furnished with the 1978 motor to the dashboard trim switch already installed.

▣ NOTEWE RECOMMEND THAT THE ORIGINAL REMOTE CONTROL STAY WITH THE ORIGINAL OUTBOARD MOTOR RATHER THAN STAYING WITH THE BOAT AND BEING ADAPTED TO THE NEW OUTBOARD. THE REMOTE CONTROL AS SUPPLIED WITH AN ENGINE WAS DESIGNED WITH THE PROPER ELECTRICAL CABLES FOR THE ELECTRICAL REQUIREMENTS OF THAT ENGINE. THOSE MAY NOT BE IDENTICAL TO A NEWER ENGINE. IN THE EVENT THAT THERE WOULD BE A SERVICE BULLETIN ON A PARTICULAR CONTROL, THE ONLY WAY WE CAN NOTIFY DEALERS AND CUSTOMERS IS THROUGH THE OUTBOARD MOTOR MODEL AND SERIAL NUMBER.
Johnson Outboards

D. J. Leinonen
Technical Data Coordinator
CR78-33