Johnson Service Bulletin SB-1480 - Special Crankshaft Seal Rings

Issued in August 1978, this bulletin identifies special oversized crankshaft seal rings for certain Johnson V-4 and V-6 engines and explains how to recognize the affected crankshafts.

Johnson Service Bulletin letterhead
SB-1480
August, 1978
SUBJECT: SPECIAL CRANKSHAFT SEAL RINGS
MODEL:   V-4 & V-6
There are some V-4 and V-6 crankshafts manufactured that require a larger seal ring than has previously been provided for service. This seal ring carries P/N 324817 and can be identified by its measured width (.1605 - .1610) and is marked with four white stripes. This special seal ring is used on crankshafts identified with the letter “S” and one or more numbers stamped on top of the counterweight. (See illustration.) The numbers designate groove numbers where this special seal ring is to be used. For example, S25 indicates that 324817 Seal Ring is used in grooves #2 & #5. The crankshafts can also be identified by yellow dykem on the outside of the ring groove or grooves that are oversize.
Use of the wrong seal ring in these applications will cause the motor to run rough at idle.
Factory crankshaft illustration showing nine numbered seal-ring groove positions and location of S identification
Johnson Outboards

D.J. Leinonen
Technical Data Coordinator
CR 78-27
Note: Post on 85 through V-6 indexes under heading “Powerhead.”

Factory reference

Special seal ring P/N 324817; affected grooves are identified by the S marking and stamped groove numbers on the crankshaft counterweight.