Johnson Service Bulletin SB-1481 (August 1978) - Tilt and Reverse Lock Lever Lock Up

Factory correction for a manual-tilt lock lever that can travel beyond its stop on 1977 140 HP and 1978 70/75 HP and V4 outboards.

Johnson Motors Service Bulletin factory letterhead
SB-1481
August, 1978
SUBJECT: TILT AND REVERSE LOCK LEVER LOCK UP
MODELS: MANUAL TILT 1977 140 H.P. AND 1978 70/75 AND V-4 MODELS

We have reports that the tilt and reverse lock lever has been found to turn beyond the stop boss on the swivel bracket causing the motor to seize in the tilt position. A redesigned swivel bracket will be incorporated in 1979 models to correct this from occurring.

As a field fix for existing motors, we recommend bending the stop on the tilt and reverse lock lever an additional 3/32 of an inch as shown in Figure 1. Clamp the stop end of the lever in a vise and use a large crescent wrench or large vise grip held close to the bend line and bend the lever 3/32 of an inch. This will provide an extra measure of stop without allowing the lever to go beyond the boss on the swivel bracket.

Figure 1: tilt and reverse lock lever and shaft, part numbers 387813 and 390097, showing the 3/32 inch bend
Johnson Outboards

D.J. Leinonen
Technical Data Coordinator
Note: Post on 70 through 140 hp indexes under heading “Lower Unit.”
CR 78-65