Johnson Service Bulletin SB-1484 - Starter Pawl Return Spring

Issued in November 1978, this factory bulletin identifies early-production 1979 Johnson 9.9 and 15 H.P. engines requiring starter pawl return spring P/N 325913 and illustrates its installation.

Johnson Service Bulletin letterhead
SB-1484
NOVEMBER, 1978
SUBJECT: STARTER PAWL RETURN SPRING P/N 325913
MODELS: 1979 9.9/15 H.P.

A starter pawl return spring was added to the 1979 Johnson 9.9 and 15 H.P.

Some early production Johnson models were shipped without this spring installed. The following serial numbers are the engines affected:

ModelBeginning
Serial Number
Ending
Serial Number
10R795036001503669510EL7950452015045248

If these engines are in your stock or previously sold, please contact your Service Department and request the spring under P/N 325913. .5 hours labor will be paid for this installation.

The following procedure should be followed to install the starter Pawl Return Spring.

1. Spring part number 325913 is shown in Fig. 1.
Figure 1: starter pawl return spring Figure 2: spring installation in starter lock
2. Compress the spring with two fingers and slide
the coil of the spring down through the hole in the
starter lock out as shown in Fig. 2.
3. The spring is shown partially in place in Fig. 3.
4. Spring shown completely in place in Fig. 4.
Figure 3: spring partially installed Figure 4: spring fully installed
JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator
NOTE: Post on 9.9 & 15 h.p. Index under heading “Miscellaneous.”
CR 78-70