Johnson Service Bulletin SB-1485 (December 1978) - V-6 Starter Mounting Boss

Factory instructions for repairing a broken starter mounting boss on Johnson V6 outboards, including epoxy bonding, drilling, tapping, and final torque specifications.

Johnson Service Bulletin factory letterhead
SB-1485
DECEMBER, 1978
SUBJECT: V-6 STARTER MOUNTING BOSS
MODEL: ALL V-6'S
It has been brought to our attention that the upper rear starter mounting boss on some V-6 outboards may break in severe service.
Breakage of this boss may occur where the bottom starter mounting bolt is loose and the full starting load is placed on the top bosses.
When encountering a broken boss as shown in Figure 1, a salvage procedure to provide threads in solid section would be as follows:
Factory photograph Figure 1Factory photograph Figure 3
1. Remove the starter motor and apply DeVcon® 5 minute epoxy or equivalent 5 minute epoxy. This can be purchased at your local hardware stores. This kit is shown in Figure 2.
2. Follow the instructions on the DeVcon carton and mix thoroughly as shown in Figure 3.
3. Apply DeVcon to both broken surfaces, press the broken boss on the casting as shown in Figure 4.
Factory photograph Figure 2Factory photograph Figure 4
4. Bolt the starter motor on the engine with the top front bolt and the bottom bolt.
5. Use a letter F drill, wrapping tape 2-3/8” from the end of the drill. Use the tape as your guide to drill the hole 2-3/8” deep. Use hole in the starter bracket as a guide to drill the hole straight as shown in Figure 5.
Factory photograph Figure 5
6. Next use an 11/32” drill. Tape the drill to the depth of the fracture as shown in Figure 6.
Factory photograph Figure 6
7. Drill the hole as shown in Figure 7.
Factory photograph Figure 7
8. Using a 5/16-18 starting tap, tap to the bottom of the hole. Clean the chips out of the hole. Use a bottom tap to assure threads are to the full depth of the hole as shown in Figure 8.
Factory photograph Figure 8
9. Install a 2” long bolt (P/N 306424) and torque all bolts to 10-12 ft. lbs. or 14.0-16.0 N.m.
Factory photograph Figure 9
CR 78-69
NOTE: Post on V-6 index under heading “Miscellaneous.”
JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Digital Multimeter & Marine Electrical Connector Kit

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 306424

Search for original or compatible replacement part 306424. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.