Back to previous page

SB-1486 - Reed Tachometer Accuracy and Propping

Issued December 1978, this Johnson Service Bulletin explains why engine RPM should be checked with a known-accurate tachometer before choosing a propeller. It identifies the Frahm Resonant Reed Tachometer, OMC part 505952, as a factory-recommended shop test instrument.

Johnson Service Bulletin factory letterhead
SB-1486

December, 1978

SUBJECT: REED TACHOMETER ACCURACY AND PROPPING

MODELS: OUTBOARDS AND STERN DRIVES

If boat performance is less than expected or if the engine seems to be sluggish, even though the boat tachometer indicates correct RPM range for that model engine, be sure to cross-check the boat tachometer.

NEVER ASSUME THAT THE DASH TACHOMETER IN A BOAT IS CORRECT.

The boat tachometer is not necessarily always a reliable means of determining the actual RPM of the engine, and should never be relied upon for accuracy until it has been cross-checked with a good quality shop tach or at least a tachometer of known accuracy.

Using an incorrect reading tachometer to select a propeller could result in either serious damage or bad performance.

Inaccurate tachometers, if not adjustable, should be replaced.

We have found one of the most accurate and easy to use tachometers for testing engine RPM and other tachometers accuracy to be the Frahm Resonant Reed tachometer. These tachometers are made with carbon steel reeds which vibrate in exact response to the RPM of the engine under test and can be read to within 25 RPM.

These tachometers are now available from your OMC Distributor under part number 505952 and would be a valuable service tool for your shop.

FRAHM RESONANT REED
TACHOMETER

PART NUMBER 505952
Factory photograph of Frahm resonant reed tachometer, part 505952
JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
CR 78 - 68
NOTE: Post on Miscellaneous index under heading “Test Equipment.”