Johnson Service Bulletin SB-1488 - Armature Plate and Pilot Replacement Kit

Issued January 1979, this Johnson bulletin describes repair kit P/N 389813 for worn armature plate pilot bearings on 1974-1976 9.9 and 15 H.P. outboards and 1976 35 H.P. models.

Johnson Service Bulletin factory letterhead
SB-1488
January, 1979
SUBJECT: ARMATURE PLATE AND PILOT REPLACEMENT KIT P/N 389813
MODELS: 1974 - 1976 9.9 & 15 H.P. and 1976 35 H.P.
When complaints of spark plug fouling or excessive movement of the armature plate lead to the discovery of a worn armature pilot diameter on the cylinder block, it is not necessary to replace the cylinder and crankcase assembly on powerhead. See Figure 1.
Figure 1: worn armature pilot diameter
Installation of the Kit P/N 389813 will eliminate the breaker point fluctuation which caused the spark plug fouling. Use this kit only if there is wear at the pilot bearing since there are a number of other causes of spark plug fouling such as weak ignition, scored cylinders, too heavy oil to gas ratio, use of poor quality oil, overpropping (too large pitch for boat and average load carried), engine sitting too deep in water, wrong spark plugs, etc.
The new armature plate and pilot replacement Kit P/N 389813 (Figure 2) is now available at a special net price (no discount). Installation of this kit is considered a maintenance item not normally eligible for warranty consideration. It will save the customer the higher cost of a cylinder and crankcase or powerhead along with their higher installation costs.
Figure 2: replacement kit components with factory part numbers
CR 78-73
NOTE: Post on 9.9, 15 and 35 h.p. indexes under heading, “Ignition”
FOOTNOTE: Change part number for .028 orifice on page 2 of SB-1453 to P/N 322936
JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator

Related factory reference

SB-1453 is corrected by the footnote in this bulletin: the .028 orifice part number on page 2 should read P/N 322936.