Johnson Service Bulletin SB-1491 (February 1979) - Carburetor Improvements

Factory instructions for correcting lean idle on early-production 1979 Johnson 175 HP outboards, including serial-number breakpoints and installation of revised idle air bleeds.

Johnson Service Bulletin letterhead
SB-1491
FEBRUARY, 1979
SUBJECT: CARBURETOR IMPROVEMENTS
MODELS: 1979 175 H.P.
Mid year changes to the 175 H.P. carburetors have improved the low speed idle performance with a change to the idle air bleeds. Carburetors with these improvements have the letter “E” stamped on the carburetor body.
Engines with serial numbers prior to these changes are:
JOHNSONFIRST SERIAL NUMBERS
WITH NEW IDLE ORIFICES
Model 175TL7905168567
Model 175TXL7905169865
EVINRUDE
Model 17594901155
Model 17594001107
Engines with serial numbers prior to these numbers which show indications of lean idle which cannot be corrected with proper throttle synchronization should have the following:
New idle air bleeds should be installed in the carburetor castings following these instructions:
A.Remove the carburetors from the engine and remove the carburetor float bowls.
B.Using a 1/8” diameter flat end punch, drive the two idle air bleeds into the body an additional 3/16”. See Figure 1.
C.Using the same punch, install new idle air bleeds, P/N 318494, supplied by your Service Department.
D.Reinstall the carburetor float bowls and carburetors to the engine. Connect carburetor linkage and synchronize the carburetors as shown in your Service Manual.
Figure 1: installation points for new idle air bleeds in the carburetor casting
For this work file a warranty claim with engine model and serial number requiring new idle air bleeds and six new idle air bleeds, P/N 318494, will be returned along with payment for two hour’s labor for their replacement and test time. Send warranty claim attention J372 or call 312/689-6293.
NOTE: Post on the V-6 index under heading “Carburetion.”
JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator
CR 79-8
©OUTBOARD MARINE CORPORATION 1979 ALL RIGHTS RESERVED

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Outboard Ignition Spark Tester & Digital Multimeter

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 318494

Search for original or compatible replacement part 318494. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.