Back to previous page

SB-1492 - Carburetor Improvements

Issued February 1979, this Johnson Service Bulletin describes improved high-speed nozzle air bleeds for 1979 150 H.P. carburetors, with installation instructions and serial-number identification for affected engines.

Johnson Service Bulletin letterhead
SB-1492

FEBRUARY, 1979

SUBJECT: CARBURETOR IMPROVEMENTS

MODELS: 1979 150 H.P.

Mid year changes to the 150 H.P. carburetors have improved the wide open throttle durability and performance with a redesigned high speed nozzle air bleed. If you receive customer complaints of his engine not “turning up”, replacement of the high speed nozzle air bleeds will bring improved performance.

Replace the original high speed nozzle air bleeds with new high speed nozzle air bleeds, P/N 322812. See Figure 1. Use an “easy out” to unscrew and remove the original air bleeds and carefully drive in the new #322812 air bleed tubes until they bottom on their shoulder. This must be done without damaging the end of the tube. See Figure 2.

Figure 1: removing original high speed nozzle air bleedsFigure 2: installing 322812 high speed nozzle air bleeds

Carburetors which have the improved high speed nozzle air bleeds installed at the factory have the letter “C” stamped on the outside of the carburetor body.

Only engines built prior to the following Serial Numbers have not had these improved high speed nozzle air bleeds:

MODELFIRST SERIAL NUMBER
WITH NEW HIGH SPEED
JOHNSON
Model 150TL7905166258
Model 150TXL7905174523
EVINRUDE
Model 15094901401
Model 15094001021

Contact your Service Department with the model and serial number of an engine needing the new high speed nozzle air bleeds, using a warranty claim form. The six new high speed nozzle air bleeds will be returned along with payment of one hour’s labor for the replacement. Send warranty claim attention J372 or call 312/689-6293.

CR 78-80
© OUTBOARD MARINE CORPORATION 1979 ALL RIGHTS RESERVED
NOTE: Post on the V-6 index under heading “Carburetion.”
JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator

Factory bulletin: Johnson Service Bulletin SB-1492 (February 1979). Part number: 322812.