SB-1493 - Correct Float Chamber Gasket Usage
Issued in April 1979, this Johnson Service Bulletin identifies the correct float chamber gasket for 1978 and later V-4 and V-6 carburetors equipped with idle air bleed systems.

SB-1493
APRIL, 1979
SUBJECT: CORRECT FLOAT CHAMBER GASKET USAGE
MODEL: ALL V-4 & V-6
The 1978 and later V-4 and V-6 model carburetors use an idle air bleed system which requires a different float chamber gasket than has been used on prior models. The difference in these gaskets is the two triangular shaped holes as shown below. The 1978 V-4 and V-6 parts catalogs list Part No. 314884 Float Chamber Gasket, which is incorrect. There are also some V-4 and V-6 Carburetor Repair Kits (Part No. 383906 for V-4 and 387730 for V-6), which have been assembled with these old gaskets.
If you use these repair kits on '78 and later V-4 and V-6 models, make sure you have the float chamber gasket with the two holes as shown, (Part No. 323784). These new type gaskets can also be used in place of 314884 on '77 and prior V-4 and V-6 models.
Part No. 314884
1977 & prior V-4 & V-6
1977 & prior V-4 & V-6
Part No. 323784
1978 & later V-4 & V-6
1978 & later V-4 & V-6

NOTE: Post on V-4 & V-6 index under heading “Carburetion.”
JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator
D.J. Leinonen
Technical Data Coordinator
CR 79-10
© OUTBOARD MARINE CORPORATION 1979 ALL RIGHTS RESERVED
Related factory information
Gasket P/N 323784 supersedes the incorrect application of P/N 314884 for 1978 and later V-4 and V-6 carburetors. Repair kits referenced: 383906 and 387730.