Johnson Service Bulletin SB-1499 - Lower Motor Cover Rattle on V-4 Models
Issued in June 1979, this factory bulletin explains a washer adjustment for rattling lower motor covers on Johnson V-4 outboards and includes corrections to 4 H.P. and 55 H.P. parts catalogs.

SB-1499
June 1979
SUBJECT: LOWER MOTOR COVER RATTLE ON V-4 MODELS
MODELS: 1979 V-4 MODELS
If you receive complaints of a V-4 lower motor cover that vibrates or rattles because of contact with the air silencer base trunnion block boss, two extra washers can be added between the cover's mounting boss and grommet as shown in Figure 1. This applies to 1977 through 1979 models and two washers, P/N 302407, should be added on each front side mounting boss.

FOOTNOTE NO. 1: There is an error on page 13 of the 1979 - 4HP parts catalog. Change the number of the extension kit on the 4HP weedless model from 389221 to 390989. A change in the upper spline on the 1979 - 4HP drive shaft made the change in kit number necessary.
FOOTNOTE NO. 2: There is an error on page 21 of the 1977 and 1978 - 55HP parts catalogs. Change part number 318841 (Ref No. 71) thrust bushing to 320305.
Note: Post on 85 thru 140 Indexes under heading “Miscellaneous”.
JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
D. J. Leinonen
Technical Data Coordinator
CR 79-39
© OUTBOARD MARINE CORPORATION 1979 ALL RIGHTS RESERVED
Factory notes
The washer installation applies to 1977-1979 V-4 models. The original bulletin also corrects the 1979 4 H.P. extension kit and the 1977-1978 55 H.P. thrust bushing listings.