SB-1502 Rev. 1 - Commercial Use of Larger Outboard Motors

Issued in November 1979, this revised Johnson service bulletin recommends low-compression cylinder-head kits, propeller selection, and lubricants to extend engine life in commercial service. It replaces the original CR 78-66 bulletin.

Johnson Service Bulletin header
SB-1502 Rev. 1
November, 1979
SUBJECT: COMMERCIAL USE OF LARGER OUTBOARD MOTORS
MODELS: 1977 AND LATER 70/75 H.P., V-4, V-6
PLEASE DISCARD ORIGINAL BULLETIN CR 78-66 AND REPLACE WITH THIS UPDATED VERSION
Commercial operators using our larger outboard motors and wishing to extend the useful service life of
these motors, may be helped by the following:
1. On 1977 and later motors, install the respective low compression cylinder head kit. These
kits will lower the combustion pressures and temperature with some associated loss in per-
formance.
MODEL
KIT PART NUMBER
1974-1978 70 H.P. & 75 H.P.
387071
1979 70 H.P.
390907
1979 75 H.P.
390908
1977 & 1978 85 H.P.
389490
1979 & later 85 H.P.
389187
1977 & later 115 H.P. & 140 H.P.
389187
All V-6 except 1980 235 H.P.
389489
2. Select a propeller for these applications that enables the motor to run in about the middle of
the recommended R.P.M. range at full throttle. This provides the best compromise for fuel
economy, durability and performance, especially in commercial use.
The above two steps should be used in conjunction with the lubricant and fuel recommended or specified
in the Owner’s Manual.
The use of Johnson 50/1 Lubricant, or equivalent BIA TC-W certified lubricant, which is formulated to
give best engine performance with least combustion chamber deposits, least piston varnish, maximum spark
plug life and best lubrication, is critical in providing good engine life. This should especially be stressed
to all commercial operators.
NOTE: Post on 70 thru V-6 indexes under heading
“Powerhead”.
CR 78-66
JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator
© OUTBOARD MARINE CORPORATION 1979 ALL RIGHTS RESERVED