Johnson Service Bulletin SB-1503 - Carburetor Bowl Vent Screen and Choke Spring Tension

Issued August 1979, this bulletin introduces a carburetor bowl vent screen to prevent insect-related jet blockages and revised choke spring recommendations for 20, 25, and 35 H.P. outboards.

Johnson Service Bulletin letterhead
SB - 1503
August 1979
SUBJECT: CARBURETOR BOWL VENT SCREEN 20 THRU V-6 MODELS
CARBURETOR CHOKE SPRING TENSION - 20 - 25 - 35 MODELS
It has been reported that, in some areas of the country (Wisconsin for one), dealers have been finding small insects plugging carburetor jets resulting in irregular engine performance. Experience has shown that cleaning the carburetor does not eliminate the problem during the season these insects are active. Apparently, the insects enter the float bowl through the bowl vent and eventually end up in the jets.
A bowl vent screen has been made available and will effectively prevent entry of the insects into most carburetors. The screen (326325) is placed in the bowl vent, the silencer gasket is placed over the screen and the air silencer is fastened in position retaining the screen. Figure 1 illustrates the parts involved. The screen fits carburetors on 20-75 HP models 1967 thru present, V-4 models 1967 thru present and V-6 models 1976 thru present.
Some owners of 20-25-35 Outboards have experienced hard starting problems especially in colder weather. This can be improved by winding the choke override spring one extra turn on the choke shaft. A new stronger choke spring P/N 326273 for 20-25 models; P/N 326274 for 35 models is also available for these models. 326273 is colored red and 326274 is colored yellow for identification.
Figure 1 - carburetor bowl vent screen location
Johnson Outboards
D. J. Leinonen
Technical Data Coordinator
Note: Post on 20 HP thru V-6 Indexes under heading
“Carburetion”.
CR 79-38
© OUTBOARD MARINE CORPORATION 1979 ALL RIGHTS RESERVED