Back to previous page

SB-1505 - 25 H.P. Propeller and Driveshaft Breakage

Issued August 1979, this Johnson bulletin explains how to distinguish bending-fatigue driveshaft failures from propeller-impact failures on 1977 and 1978 25 H.P. outboards. It lists updated driveshafts, gearcase alignment tolerances, and propeller slip-torque inspection guidance.

Johnson Service Bulletin factory letterhead
SB-1505

August 1979

SUBJECT: 25 H.P. PROPELLER AND DRIVESHAFT BREAKAGE

Driveshaft Breakage 1977 or 1978 25 H.P. -

Driveshaft breakage on 1977 or 1978 25 H.P. models can result from either bending fatigue or propeller impact type failures. To reduce the likelihood of a repeat failure, the driveshaft on 1977 25 H.P. models should be replaced with either P/N 325800 (standard length) or 325801 (long); the driveshaft on 1978 25 H.P. models should be replaced with either P/N 325802 (standard length) or P/N 325803 (long). These new driveshafts can be identified by a necked down section at the top.

Bending Fatigue Failure -

A bending fatigue failure of the driveshaft will appear as a somewhat irregular break surface but it is usually worked smooth over a portion of the break. Misalignment of the driveshaft caused by bent or mis-machined parts will aggravate this condition. The top and bottom surface of the five inch extension on the gearcase should be parallel within .001 per inch. The bottom surface of the exhaust housing should be parallel to the top surface within .009 total and not exceeding .001 per inch. These parts should be replaced if they are questionable.

Propeller Impact Failure -

A driveshaft failure from propeller impact will appear as an extremely flat break surface that almost looks as if it were machined. Using a stronger drive pin than an OMC equivalent on 1977 models, or a propeller hub slip torque of over 160 foot pounds on 1978 models, can aggravate the failure. The propeller torque fixture, P/N 378448, in conjunction with a nut welded on to a 1978 25 H.P. propshaft can be used to insure that the slip torque is not excessive and that the propeller hub is not seized into the propeller from salt water corrosion.

Johnson Outboards

D. J. Leinonen
Technical Data Coordinator