Johnson Service Bulletin SB-1516 Rev. 1 (May 1980) - Carburetor Jet Change

Johnson factory carburetor calibration changes for 1980 85 HP and 140 HP outboards, including idle air bleed and intermediate orifice specifications and identification markings.

Johnson Motors Service Bulletin letterhead
SB-1516 Rev. 1

May, 1980

Subject: Carburetor Jet Change

Models: 1980 - 85 and 140 HP Outboards

There has been a change in carburetor calibration on 1980 Johnson 140 HP models to improve idle characteristics in cold weather. The four idle air bleed orifices were changed to .025 (P/N 323003) from .027. If you find a 1980 140 HP that exhibits a lean idle condition in cold weather, install four P/N 323003 .025 idle air bleed orifices.

Late production 140 HP motors were built with this jet change and can be identified by the stamped letter “F” following the assembly part number on the carburetor body.

There has also been a change on 1980 85 HP models to improve a lean running characteristic at 1500 to 2500 RPM. The four intermediate orifices were changed to .027 (P/N 317474) from .023. This is only for 1980 85 HP motors that have carburetors with a 1-3/16” bore (P/N 391347 upper and 391348 lower). Early production motors had 1” bore carburetors. If you find a 1980 85 HP that exhibits a lean running condition at 1500 to 2500 RPM, install four intermediate orifices P/N 317474. Mark the carburetor body with an “A” after the part number to show this jet change has been made.

Late production 1980 85 HP engines were built with this jet change and can be identified by the ink stamped “.027” on the carburetor body.