Johnson Service Bulletin SB-1524 (March 1980) - Fuel Line Vacuum Tester

Johnson warned dealers that improper installation of special tool P/N 390954 could damage its vacuum gauge. This bulletin provides the proper testing sequence for V-4 and V-6 outboards with built-in fuel systems.

Johnson Motors Service Bulletin factory letterhead
SB-1524

March, 1980

Subject: Fuel Line Vacuum Tester - Special Tool P/N 390954

Models: All V-4 And V-6 Outboards Using Built-in Fuel Systems

It has come to our attention that damage can be caused to the vacuum gauge if installed to engine prior to priming the fuel line.

The instructions supplied with the gauge should be supplemented with the following procedure to prevent damage to this vacuum gauge.

Note

This is a vacuum gauge and can be damaged if pressure is applied with squeeze bulb. Follow instruction in next paragraph.

Start and run engine before installing vacuum tester. Shut engine off after operating temperature is reached. Disconnect fuel line from engine. Connect fuel line vacuum tester between built-in fuel line and engine. Do not squeeze primer bulb after vacuum tester is installed as this will damage gauge. Re-start engine and proceed with test.

JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator
NOTE: Post on V-4 and V-6 indexes under heading “Carburetion.”
CR 80-19   ©OUTBOARD MARINE CORPORATION 1980 ALL RIGHTS RESERVED

Factory reference

OMC special tool P/N 390954 - fuel line vacuum tester. Follow the bulletin's priming and installation precautions before conducting a test.

1970-1980 Johnson Service Bulletin Index