Johnson Service Bulletin SB-1528 (April 1980) - Improved Idle Quality

Factory carburetor adjustments and lean-idle diagnosis for 1980 50 HP and 1979-1980 70/75 HP Johnson outboards.

Johnson Service Bulletin letterhead
SB-1528

April, 1980

Subject: Improved Idle Quality

Models: 1980 50 HP, 1979 & 1980 70 and 75 HP

1980 50 HP outboards, which stall after prolonged idle, can be improved by the following procedure:

Check throttle linkage synchronization and spark-throttle cam pick-up setting for accuracy and set idle speed to 750-800 rpm in forward gear. Idle for 15 minutes and evaluate for stalling.

If the engine still exhibits stalling, the carburetor should be modified as follows:

1. On carburetors 391579 (lower) and 391580 (upper), remove the calibration pocket core plug and enlarge the idle-fuel feed hole to 0.042 inch diameter using an Index Drill #58. The idle-fuel feed hole is the hole located closest to the carburetor mounting flange.

2. After modifying the carb, add the letter “A” after the carburetor part number using an indelible ink marker.

3. Install new core plugs, install carbs and set throttle linkage synchronization and spark-throttle cam pick-up setting and check idle rpm.

If the carburetors have the suffix letter “A” after the stamped part number on body, then this modification has been made at the factory.

1979 and 1980 70/75 HP models that stall after prolonged idle or hesitate on acceleration should be diagnosed as follows:

1. Remove the choke connector links between carburetors.

2. Determine which carb is lean by snapping the choke plate closed momentarily one at a time while idling at 750 rpm in gear.

3. If the engine gains in rpm, that particular carb is defective.

4. If the carb is not defective, the rpm will decrease or the engine will stall when momentarily choked.

5. It is possible to have one or more defective carbs on an engine, so check all three.

Replace the faulty carburetor with:

1979 & 1980 70 HP: 391608 Upper & Lower Carb Assembly; 391609 Middle Carb Assembly.

1979 & 1980 75 HP: 391633 Upper & Lower Carb Assembly; 391632 Middle Carb Assembly.

If poor acceleration is the complaint, the same diagnostic method can be used by momentarily snapping the choke plate closed while accelerating.

JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator

Factory filing note: Post on 50-70 and 75 hp indexes under heading “Carburetion.”

Factory reference: SB-1528, April 1980. Original procedures and part numbers are retained for historical research.

1970-1980 Johnson Service Bulletin Index

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Carburetor Cleaner Spray, Jet Cleaning Wires & Rebuild Kit

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 391579

Search for original or compatible replacement part 391579. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.