Back to previous page

SB-1536 - Modification for Special Tool, Power Tilt & Trim Stand

Issued May 1980, this Johnson Service Bulletin describes a modification to Power Tilt and Trim Test Stand P/N 390008 for servicing V4 and V6 tilt and trim units with Pressure Tester Gauges P/N 390010. The original photograph and cutting template are reproduced on two factory pages.

Johnson Service Bulletin letterhead
SB-1536

May, 1980

Subject: Modification for Special Tool
         Power Tilt & Trim Stand P/N 390008

Models: V-4 & V-6 Tilt & Trim

It has been recommended that a slight modification to the new Power Tilt and Trim Test Stand, P/N 390008 can allow bench testing of the unit after repairs using the Tilt & Trim Pressure Tester Gauges, P/N 390010.

Access to the manual release valve can be provided by cutting one side of the stand with a hacksaw as shown in Figure 1. The template on the reverse side will serve as a guide for marking the portion of the stand to remove.

Figure 1: modified power tilt and trim test stand with side cut away
Full-page factory cutting template showing cut line and shaded portion to remove from power tilt and trim stand
NOTE: Post on miscellaneous index under heading “Tools.”