SPB-336 - Outboard Motors - Submersion

Issued April 3, 1963, this Johnson Motors Service Promotion Bulletin describes corrosion and mechanical damage following outboard motor submersion, including the importance of prompt inspection and repair.

Johnson Motors Service Promotion Bulletin letterhead
April 3, 1963
SUBJECT:   OUTBOARD MOTORS - SUBMERSION
Labeled outboard motor components affected by submersion
POINTING OUT COMPONENTS OF THE OUTBOARD MOTOR ASSEMBLY
AFFECTED BY SUBMERSION

Overboard (submerged) motors often present a some what perplexing problem when brought into the shop for attention - sometimes leading to disagreeable misunderstanding with the owner unless he is made aware of the destructive conditions frequently associated with submersion. He may not realize or understand at the moment just what precautionary steps are necessary and advisable during the process of restoring operation. A tactful explanation and an appraisal of restoration cost should lead to a mutual understanding before actually commencing the job. An immediate decision and the owner's consent to proceed, however, is imperative.

Page 2
SPB No. 336
Factory photographs of piston and connecting rod assembly, crankshaft and filler block assembly, and cylinder bore damaged by submersion

The process of rusting and/or corrosion as a result of submersion simply will not await delayed attention it goes to work at once and as such, attacks the highly machined surfaces of motor parts and components of the electrical system with disastrous and costly results.

The illustrations here shown, reveal emphatically the effects of belated or improper attention after submersion and speak for themselves. In this instance, the motor involved was recovered from salt water submersion but for some reason was not given prompt and proper attention.

Submerged motors brought to a dealer must be assumed to have been exposed to the atmosphere for several hours after recovery.

As the modern outboard motor has a full complement of anti-friction bearings, both roller and ball as well as needle, a complete tear-down of the powerhead is mandatory. Both fresh water and salt water will start etching the highly machined bearing surfaces on the crankshaft and connecting rods as well as the bearings themselves. If caught early enough, the bearing surfaces may be cleaned up if the etching is not too severe. Rarely can the bearings be saved. It is quite risky to try to re-use submerged bearings, especially if submerged in salt or silt-laden water. Replacement of bearings should be made.

Many motors, especially V-4 cylinder models have magnesium "filler blocks" bolted to the crankshaft. Once exposed to salt water submersion, these magnesium blocks and any other magnesium parts must be replaced as immediate and continuous corrosion begins. This is true regardless of the length of time submerged. Fresh water, containing certain minerals and alkalines will also have a deteriorating effect on magnesium parts which would dictate replacement.

Submersion of electrical components such as starter motors, D.C., generators, alternator generators, ignition systems, (both magneto and battery) junction boxes and regulators, etc. will require immediate attention and tear down. Salt water submersion generally requires greater repair and replacement of parts than fresh water submersion.

Historical notes

This publication emphasizes immediate attention to submerged engines, with special concern for bearings, magnesium filler blocks, and electrical components. The original document is dated 1963 and is filed here with the assigned 1970s archive production batch.

1970-1980 Johnson Service Bulletin Index