Subject:How To Adjust Throttle Cable - 4.5 & 7.5
Models:1980-1981 - 4.5 & 7.5
With the throttle cable installed in the steering handle, the handle attached to the steering bracket, and the cable routed through the pan to the control lever, proceed as follows:
- Set idle adjustment knob to minimum idle speed (all the way out).
- Be sure cable connector 324386 - 4.5 (Figure 1, Item 1), 324685 - 7.5 (Figure 2, Item 1) is threaded onto cable housing. Install cable connector 324384 - 4.5 (Figure 1, Item 2) or pivot pin 325309 - 7.5 (Figure 2, Item 2) on end of throttle cable so that one full thread protrudes beyond connector.
- Attach connector/pivot pin to throttle control lever - 4.5 (Figure 1, Item 3) 7.5 (Figure 2, Item 3).


- Adjust cam follower to begin opening throttle when it is between the marks on the cam.
- Turn throttle grip to full throttle as far as it will go.
- Bring stator plate to full advance position. Turn cable connector until attachment hole in connector is aligned with tapped hole in mounting boss. Turn connector one or two additional turns to pre-load cable (increase distance between connector and cable end).
- Install anchor screw and other hardware. Check to see that twist grip will advance stator to maximum advance stop. Check to see that cam follower is off of the cam when twist grip is set at idle position. If full throttle or minimum idle is not attainable, turn cable connector one turn at a time until setting is okay.
- Be sure all fasteners are secured properly.