OMC Service Bulletin No. 2010 - Replacing Seal on Adaptor to Power Tilt and Trim Gauge P/N 390010

OMC bulletin describing replacement of the seal on the adaptor used with power tilt and trim gauges, part number 390010.

OMC Outboard Service Bulletin
Service Tools

No. 2010
October, 1980

Subject:
Replacing Seal on Adaptor to Power Tilt and Trim Gauge P/N 390010

We have found that the bonded seal on the tilt and trim gauges can be damaged causing them to leak under pressure. The seal can be replaced as follows:

  1. Use a knife and carefully remove the damaged bonded seal from the groove and surface tips of adaptor. Do not damage surface of adaptor while cleaning. After seal is removed, spray on OMC Cleaning Solvent P/N 390905 and flush away dirt and oil from tip of adaptor. See Figure 1.
  2. Use O-ring (P/N 322598) for a replacement seal. Apply Loctite Superbonder 495 from a Gluematic pen. Follow directions on pen for proper use. Apply glue in groove of adaptor. Assemble O-ring over tip and press adaptor and O-ring on a flat surface for a few minutes to allow Superbonder to dry.

Loctite Superbonder 495 can be purchased at your local hardware store.

Factory figure 1Factory figure 2

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Loctite 495 instant adhesive

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 390010

Search for original or compatible replacement part 390010

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.